ATLAS 3D Scanner by Murobo
Have us print this for you
PLA from £6 inc. UK delivery on letter-sized prints. We slice, print on a calibrated Creality K2 / Bambu A1, QC and post.
These are the printable models for the ATLAS 3D turntable laser scanner by Murobo. ATLAS 3D is a turntable 3D laser scanner based on the Raspberry Pi. It runs the open source FreeLSS http://www.freelss.org laser scanning software available on Github https://github.com/hairu/freelss/. ATLAS 3D is a successful Kickstarter that is now available to the public.
The following models are required to build ATLAS 3D:
1. camera_arm.stl, qty 1
2. camera_bracket.stl, qty 1
3. camera_case_back.stl, qty 1
4. camera_case_front.stl, qty 1
5. camera_shaft.stl, qty 1
6. frame_connector.stl, qty 6
7. frame_section_2.stl, qty 4
8. left_laser_arm.stl, qty 1
9. right_laser_arm.stl, qty 1
10. left_frame_section 3.stl, qty 1
11. right_frame_section 3.stl, qty 1
12. left_laser_holder.stl, qty 1
13. right_laser_holder.stl, qty 1
14. rpi_cable_carrier.stl, qty 4
15. crossbar.stl, qty 5
16. camera_tower.stl, qty 1
17. camera_tower_front_plate.stl, qty 1
18. table_coupler.stl, qty 1
19. calibration_item.stl or checkerboard_calibration_item.stl, qty 1
The calibrationPattern.pdf file needs to be printed and glued onto the checkerboard_calibration_item.stl model if you want to use the checkerboard auto-calibration.
Raspberry Pi 2 and Raspberry Pi 1 Model B+ users need to print the below two models.
1. rpi_case_bplus_lower.stl
2. rpi_case_bplus_upper.stl
Raspberry Pi 1 Model B users need to print the below two models.
1. rpi_case_b_lower.stl
2.…
