11th Doctor Sonic Screwdriver Redrawn

Created because I needed a good reference model for another toy crossover design. I started with TheNewHobbyist's model but redrew it from scratch using other downloaded images. I sliced up the handle into different pieces for each color so it can be show-accurate without painting. Also added a tip and core piece, fixed it so it has four prongs instead of six. Finally the telescoping part and opening prongs should actually work now. The printed model won't be spring-loaded like the actual toys and props are, so you'll have to extend it and open the prongs by hand, but the detent to hold the telescoping section retracted and the prongs in should work.

I have printed this now. Seems to print OK although there are some tricky overhangs. The core and tip should have been done in translucent green, but translucent blue was all I had on hand.

Note: minor change made to white_handle to add hexagonal indentation. Also, uploaded the source file.

Updated with hollow version, for use of those of you who intend to put LEDs or remote controls or other devices inside. The handle is also connected to the cage with a twist to release mechanism for replacing batteries. This is the version printed above, which seems to go together well but I haven't tried actually putting anything in it yet.

I have also added a version of the black part of the handle that is hollow and has a slot specifically sized for an Arduino Pro Mini.

As a warning - this model is fairly fragile. …