The Cord / Cable Coiler is a small and simple solution to keep your power cords and Ethernet cables etc. tidy and make them easier to use and /mange during use. With the Cord / Cable Coiler your cords and cables will be stored in a neat and orderly way. In use, it lets you uncoil just the length required at the time then secure the rest of the cord / cable temporarily so it won't uncoil further.... then coil the length used up again after use. The design even has rails that are useful as handles to make it easy to carry your coiled cords / cables.
This makes keeping your cords and cables in order easy and also safer in use as excess cable is not left squirming around the floor where it could cause someone to trip and fall.
The size of the Cord / Cable Coiler has been kept to the minimum to perform their function well but without consuming too much filament to print (approx. 30gm. depending on version and print settings applied) and so they don't take too long to print.
Please note that a centre brace has been added to minimise distortion when the cord is wound on fairly tightly so the print will be slightly different from the images shown.
Size guide:
Large - 7.25mm to 7.5mm diameter power cords etc.
Medium: 6.25mm to 6.5mm diameter power cords and computer cabling etc.
Small: 5.0mm to 5.25mm diameter Ethernet / computer cables etc.
Cord / Cable Lengths: The length that can be coiled differs depending on the cord / cable diameter and…
