Ursa (bear) - Fully printable Monster Truck
Have us print this for you
PLA from £6 inc. UK delivery on letter-sized prints. We slice, print on a calibrated Creality K2 / Bambu A1, QC and post.
Fully printable monster truck with four link suspension and four wheel drive and steering with three differentials. I wanted a monster truck that actually looks like a monster truck, and not a truggy with large wheels.
If you want to support my work you can use any of the Ebay or Banggood-links below before making purchases.
-----
Videos:
https://youtu.be/mVA5D9kVJJs
https://youtu.be/9wNiFeGisZw
https://youtu.be/AO-AkMLZNDA
https://youtu.be/2taKQ4_r750
https://youtu.be/wBgna8vqM7A
https://youtu.be/CZGQl6PWfFM
https://youtu.be/f0mxxbsc6S8
https://youtu.be/uLqwb3P9NfM
https://youtu.be/4p0nPPbaKH8
https://youtu.be/VDS8F1Fntyc
https://youtu.be/_6eOmHweF8k
https://youtu.be/253u5Jxf34w
----
Extra accessories:
Mega truck wheels for it: https://cults3d.com/en/3d-model/various/mega-truck-tires-for-the-ursa-1-12-scale-monster-truck
Van body: https://cults3d.com/en/3d-model/various/80-s-van-body-for-the-ursa-monster-truck
----
Assembly notes:
-Tighten the suspension arm clamps around the axle balls until they allow some movement, but not too tight. The ball joint needs to be able to move with suspension travel.
-The axle gearbox halves may have some uglyness in the top where the 7mm bearing goes. Just remove any excess plastic threads and stuff the bearing in there. I've done it to many units without failure. I might improve this part of the design later on.
-Apply a small amount of grease to the inside of all drive joints so that the plastic…
