Magnetic Dice Box, Tray, and Tower

This is a dice box, tower, and tray combo. It has a drawer for fitting 7 different types of dice (d4 d6, d8, d10, d10, d12, and d20) in a standard set. It can hold at least 7 of each type of dice (I used it with my set of 49 dice, 7 of each type.)

There are several holes for 8x1mm magnets, which facilitate keeping the drawer closed fully, as well as keeping the tower together when in use. See magnet direction pictures for polarity of magnets. Pick a direction on the magnets to call south or north, then keep it consistent.

I have included several versions with and without the designs. You will need a tray top, tray bottom, drawer, and each tower piece for a full set.

This print needs at least a 200mm bed! See misc instructions below for instructions on how to print a full 200mm object with Cura.

I printed using Hatchbox Wood Filament and using the online Wood Grain tool, then sanded and stained. I used [this website](https://www.tecrd.com/tools/stl_wood/) to make the wood grain.

<b>8/13/2019: </b> Changed pins on tray bottom into holes. For alignment, simply clip off ~10mm bits of filament to put into holes to use as pins. Holes are over sized to allow for shrinking. Tray bottom now marked v6.


<b>4/16/2019: </b> Increased height of tray bottom (now marked v5) to give a little more vertical tolerance for the drawer. All tolerances (each side of drawer, each side of tower pieces) are now 0.3mm, so make sure your printer is capable of that. If you are still…