Have us print this for you
PLA from £6 inc. UK delivery on letter-sized prints. We slice, print on a calibrated Creality K2 / Bambu A1, QC and post.
**Grab Toy ++**
==========
Introduction:
----------------------------
Had lots of problems printing the amazing Scissor Snake family (https://www.thingiverse.com/thing:1902131) with hinges fusing together and some parts snapping. So I tried to design a simpler hinge that could also be printed in place using OpenSCAD, where I could play with different spacings between the moving parts.
Then I did the code for the rest of the toy, learning OpenSCAD along the way. Very cool software!
Tips:
----------------------------
Instead of printing the biggest grabtoy here and be disappointed it fused together, you can first check which spacing works better for your printer settings by printing the HingeSlackTest() model.
The default slack of 0.5mm is a good starting point. The lowest I managed when printing PLA at 0.2mm resolution with my Anycubic I3+ at normal (i.e. fast) speed was 0.35, but only at very low temperatures (190º) which results in poorer surface finish.
I found that robustness of the toys varied a lot depending on the slicing software, with some not putting extra material in thin regions that are structurally important (mostly the cores
and shoulders of the hinges). Playing around I realized that some carefully placed thin slits forced the slicers to create extra walls, thus reinforcing some key areas. Enable or disable
them by setting REINFORCE_CORE and REINFORCE_SHOULDER to true or false.
Main…
