Forest Barrow Entrance - 28mm

[](https://go.ec3d.design/beasts-and-baddies-vol2)
--------------------

This is a forest scatter piece with an entrance to a barrow, made possible by my recently successful Kickstarter [Forest of Oakenspire](https://www.kickstarter.com/projects/ecaroth/forest-of-oakenspire-3d-printable-tabletop-models), which has late pledges available if you missed out!

This prints as 3 pieces on smaller printers, which glue together easily with alignment tabs. There's also a complete version if you wish to print it in one go. The entrance section _does_ require some support material to print well, and printing in separate pieces makes removing the supports very easy. It's scaled for 28mm but can be scaled up/down as needed.

I printed it at .24mm layer height, which made printing fast but if I had to do it again I would use .2mm to get better detailing on the stone tops by the entrance. I did _zero_ cleanup of the model as well, and you can see the joint lines easily in my pics. A quick bit of filler and sanding would have removed these. If I had to do it again, I would also have hit the stones by the entrance with a few shots of filler primer to smooth them out.

As you can see from the pic, I flocked the whole thing. I'm crappy at flocking but the end result is OK. It also looked good with just a green basecoat before flocking, so a few other shades of green could…