Two Winged Flexi Dragon

(Scroll Down to see Updates)

I made the original Flexi Dragon for my son from a model that can be found here: https://www.thingiverse.com/thing:570345 and thank you to Muzz64 for this model.
The model needed almost a complete change to make it flexi so I started my first project....the Flexi Dragon.

After requests from both my wife and friends I had worked on a two winged version. After hours and hours of work I had created and printed a very rough one but the print was full of errors because of my beginner skills, shape problems, deformations as well as supports that were heck to remove. I finally abandoned the project because of the issues and difficulties in keeping the model intact however after more requests and even more hours of working on it between my job and my son I was able to fix a lot of the errors and make it a little bit easier to print and more sturdy for wing separation.

Don't get me wrong this may not be for a beginner. Support creation and removal skills are a must. I also suggest using Cura with a zigzag support. Please do not go under the limits that are stated in the print settings because you will more than likely get a failed print or lots more issues. I am also not sure what would happen if you enlarge it. The pictured two winged flexi dragon has no sanding and is totally rough with only the supports removed. I tried to show where to start and the progression of removal. This is not perfect by any means and I only uploaded it because of…