Have us print this for you
PLA from £6 inc. UK delivery on letter-sized prints. We slice, print on a calibrated Creality K2 / Bambu A1, QC and post.
IMPORTANT:
A couple of commenters have said the drawer is too wide for their Ender 3.
Please measure the gap between the Y axis and right hand extrusions before printing anything - if the measurement is less than 115mm (or 105mm if you have a Pro) it's likely the drawer will be too tight.
This simply appears to be poor quality control from the factory, with the Y extrusion being fitted off centre/out of square. You may be able to realign it by loosening the attaching bolts underneath the cross bar.
Update 25/09/18:
Modified version for Ender 3 PRO - see below.
Update 14/07/18:
Y-axis tensioner change - see below.
-----------------------------
There a few drawer/tray type things for the Ender 3 already on Thingiverse but none quite what I wanted.
This drawer slides between the Y axis and the right hand horizontal extrusions, it is supported on both sides. When closed the front of the drawer is level with the end of the right extrusion, when opened it is level with the end of the Y axis extrusion.
You just need to temporarily remove the control panel to slide the draw in. When refitted the panel stops the drawer from pulling right out.
Owners of later Ender 3's with the double sided tensioner may find it a little trickier to fit the drawer, however there should be enough flex in the model without removing the tensioner.
The drawer has a cut down front so you can access the bed adjuster on the fly and has a stopper on the back to allow plenty of…
