Garden Irrigation Spray System / Garten Bewässerung System

Hi

here you will find a garden irrigation system like the manufacturer gardena has. Free under the motto "Why buy, when you can print it" ;-) I have designed it modularly and as GlueEdition so that you can connect different ground holders, middle parts with 1-3 direct connections / gardena coupling or different spray heads. the spray heads are still in development. However, angles of 45°, 180°, 270° and 360° are still available. I was amazed how far the spray head sprays with 2.5 - 3 bar water pressure, so a dosage with a screw in the head is available.

*Preview:*

<iframe width="560" height="315" src="https://www.youtube.com/embed/ruUPSK0xpcE" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe>

*Support material:*

The support material for the spray head is already included in the stl files ( please print the head upside down ). The fine tubes at the place where the o-ring goes in and at the spray exit is can be easily cut out with a cutter knife.
For the middle section only support material is required from the base plate.

*You need:*

- Printed parts ;-)
- Screws 3,5 x12 or 3,5x15
- O-ring inner diameter Ø 12 x 3,5 mm NBR 70 ( https://www.ebay.de/itm/401009056492 )
- M4x 25mm dosage screw

***Please note that the development is still in progress. So stay tuned!!!!***

**ALSO INTERESTING**

…