The complete BLTouch/3DTouch guide for Creality printers (CR-10/s,Ender 2,Ender 3) for Auto Bed Leveling UPDATED

**28-06-2018 - People are having issues trying to obtain the Pin 27 adapter board, there is another way around this which is a little more complicated but doesn't require the board here http://jonathanlundstrom.me/2017/10/23/cr-10-bltouch-firmware/**

**26-06-2018 - Added version 3 to add suggested changes to CR-10/Ender 3 section to make things more clear, use this version instead of v1 or v2!**

**25-06-2018 - Added a version 2 of the guide due to issues in v1, this addresses most of the issues below with more photos and screenshots to look at for installation, you should definitely use this instead of v1!**

I've tried to make this guide as simple as possible with all the resources you need in one place or linked to it, sections include;

**Before you start**

**Printers**
CR-10s /S4/S5/Mini
Ender 2
Ender 3/CR-10

**Configuring Z offset**

**Start-up GCODE**
CR-10/s
Ender 2
Ender 3

**Misc & Extras**
Remove all boot screens for faster boot times
Control ooze while bed levelling runs (Simplify3D)
CR-10 stock to CR-10s board

**This guide was created with the firmware included in the guide, please use the hyperlink in the guide to download this firmware to make sure all instructions match and make sense.**

***For CR-10 and Ender 3 please use pin 27 not 29 like it says in the guide, sorry this was over looked when creating! So please be sure to use #define* servo0_pin 27.**

I hope this helps and this is clear enough to follow, if…