BlTouch Mount For Ender 3 (remix) - no supports needed
Have us print this for you
PLA from £6 inc. UK delivery on letter-sized prints. We slice, print on a calibrated Creality K2 / Bambu A1, QC and post.
<strong> If you want to try my newer adjustable touch sensor mount, check this thing out:</strong>
https://www.thingiverse.com/thing:3148733
<strong>I generally recommend the adjustable mount over the fixed mounts for most folks, though people have had good luck using this fixed mount with the BL-Touch V3.1</strong>
This is a remix of BlTouch Mount For Ender 3 by dopesoner930 below.
https://www.thingiverse.com/thing:2990086
which is a remix of the original from shocksofmighty below:
https://www.thingiverse.com/thing:2493610
This uses the same dimensions, I just rounded some of the corners so it would not need supports.
===============================================================
<h1> Offsets </h1>
These are the offsets for this mount - thanks <strong>dopesoner930</strong> (for the original design) and <strong>danpeig</strong> for confirming the offsets:
X_PROBE_OFFSET_FROM_EXTRUDER -42 // X offset: -left +right [of the nozzle]
Y_PROBE_OFFSET_FROM_EXTRUDER -5 // Y offset: -front +behind [the nozzle]
The z-offset will be different for every printer, and must be adjusted for any probe, but one datapoint was reported as -1.75mm, when using a BL-Touch v3.1 on an Ender3 Pro (so -1.75mm should be in the ballpark).
===============================================================
Although I cannot test this anymore on my Ender3 (which uses a Titan Aero), the <strong>"ender3-bltouch-mount-4b-3mm-lower"</strong> version has been confirmed by…
