Slack Lack - The Lack Enclosure with Sliding Pocket Doors

See Video:
https://www.youtube.com/watch?v=ctuxhp6h6kc

The Slack Lack was greatly influenced by the Original Prusa Enclosure found here: https://www.thingiverse.com/thing:2864118

That being said, all of the design and CAD for this enclosure is my own. I wanted an enclosure for printing ABS but I also wanted to be able to leave the front open when printing PLA. I didn't want to have to leave the doors wide open as this sits in my living room, I knew I wanted pocket doors.

It is designed to be tall enough to hold an Ender 3 and a 30mm tall paving stone (helps in vibration reduction). The total usable height is 50cm. The doors hinge shut and latch via magnets. There are also support magnets in the hinge peices that prevent it from sliding while opening and closing the doors normally. The doors will slide back on tracks into the enclosure out the way. Finally, the doors can even be removed very easily by partially opening the door and sliding it off the magnets.

---
Purchase Parts Needed:

- Magnets 20x6x1.5mm Qty 12 (These were easier for me to find than the magnets sourced by the Prusa group)
- Screws 6x50mm Qty 8
- Screws 5x20mm Qty 14 (These were also easier to source, you'll need 2 more if you use my remote PSU bracket)
- Plexiglass 3x450x492mm Qty 3
- Plexiglass 3x214x492mm Qty 2

---
Printing:

- Expect to use nearly a full roll of filament!
- I printed everything in PETG, 20% infill, 3 walls
- I've made sure that all the parts…