RODAM Ender 3 spool holder
Have us print this for you
PLA from £6 inc. UK delivery on letter-sized prints. We slice, print on a calibrated Creality K2 / Bambu A1, QC and post.
!!( UPDATE 2019-04-28)
OKAY. I had to do a short crash course on tolerance, and here is finally 2 version of the bolt. One with a tolerance of .3 mm and another more fitted with a tolerance of .2 mm.
It works very well for me.
Printed at .18 mm with 2 wall at 40mm / sec, 15% infill.
!!!!!! (Update 2019-04-25)!!!!!
There is something wrong with the large nuts thread. so they are not there anymore. I will work another one but I'm leaving for vacation, so be patient, it will be there soon!!!
Sorry!
(UPDATE 2019-04-11)
After Trainflyer1 comment about the Bolt I've put a version 2 of the bolt with a small chamfer at the base of the thread to make it easier to screw. ;-)
(UPDATE 2019-04-08)
I added a solide cylinder to print in vase mode.
(UPDATE 2019-03-27)
As promised to miker3030, here's the bolt for the spool if you want it the same color :-)
(UPDATE 2019-03-20)
Found out that the spool was swinging too much for me sideway. So I maid a cylinder to minimize that effect.
ANOTHER spool holder, yes I know there's a lot out there!!
But hey!! I like designing :-)
So this will fit the original metal spool holder bracket with the same large Hex bolt.
!! make sure to remove any support in the fillet section, and slow the process for that fillet section to about 25mm/s2.
It uses standard 608 bearings.
https://youtu.be/PYunJk9fujo
<a rel="license" href="http://creativecommons.org/licenses/by-nc/4.0/"><img alt="Contrat Creative Commons"…
