CyberPunk 2077 Car
Have us print this for you
PLA from £6 inc. UK delivery on letter-sized prints. We slice, print on a calibrated Creality K2 / Bambu A1, QC and post.
CyberPunk 2077 car, this car is made up of many parts that need to fit each other so your printer should have a 0.4mm nozzle, otherwise you maybe wasting your time and material.
I suggest you first print wheel01.stl and wheel02.stl to see if these parts fit together well before continuing, these two parts should require abit of force to fit or separate.
WARNING this model has only been tested on a very old Ultimaker Orginal, I can not guarantee anything or that you aren't wasting your time.
Good luck!
FYI:
Suspension spring snapped (after some time), maybe better to cut a thin strip off of a solid plastic sheet instead of printing that part.
-Body02.stl and body03.stl both have printing supports modeled in to the mesh which need to be removed before fitting.
-Detail01c.stl and Detail01b.stl are not identical, arrange largest near the top and smallest to the bottom of the car.
-Print 48 X wheel04.stl (you may need more 4 more bearings if your wheels are loose)
-Print 4 X wheel03.stl
-Print 2 X wheel02.stl
-Print 2 X wheel08.stl
-Print 4 X sp01.stl
-Print 8 X sp02.stl
-Print 4 X sp03.stl
-Print 6 X sp04.stl
-Print 2 X sp05.stl
-Print 2 X sp06.stl
Here is a assembly guide:
https://www.youtube.com/watch?v=7w5hIhSNBuY
https://youtu.be/AN4QUc66IX4
Update:
https://www.youtube.com/watch?v=M1g4JVXQog4
scale: 1/20 ish.
Model dimensions: 22x11x6cm
