Raspberry Pi 4B Octoprint Case with Fan
Have us print this for you
PLA from £6 inc. UK delivery on letter-sized prints. We slice, print on a calibrated Creality K2 / Bambu A1, QC and post.
*This version is designed for a Raspi 4b with fan.
If you need the 3b+ version it is linked [here](https://www.thingiverse.com/thing:4706774).*
Update: Per a user request I've added a case version that uses 3mm case screws.
**Warning: I have two Pi4B's and neither of them have mounting holes large enough for 3mm screws. Be careful to not damage the board of your Pi.**
Update: Case_Rear.stl and Case_Rear_V2.stl files have been updated to tighten up the case screw standoff holes. This will allow the 2.5mm screws to get a better bite into the plastic.
Update: Reoriented the rear case with M2.5 nut pockets so that it is the correct orientation for printing. Also, added a rear case with nut pockets which includes a knockout panel that covers the GPIO pin slot.
Update: Per a request by [sekazi](https://www.thingiverse.com/make:724952) I added a rear case with M2.5 nut pockets. Thanks to sekazi for printing and feedback.
Update: Added Version 2 of the case.
Version 2 adds the ability to print a clear status lamp viewing lens.
Under brighter lighting conditions the status LEDs are difficult to see through the translucence of the version 1 case. I redesigned the case to separate the viewing lens from the case material.
------
Based on what I learned from doing the [remix](https://www.thingiverse.com/thing:3706018) of [Licantrop's](https://www.thingiverse.com/Licantrop) [Raspberry Pi 3 B Case Bear Upgrade](https://www.thingiverse.com/thing:2869086), this…
