Low Polygon Mask - Replicator Printable
by Austin · from Thingiverse
Personal use only
♥ 1,436 likes
↓ 15,988 downloads
Have us print this for you
PLA from £6 inc. UK delivery on letter-sized prints. We slice, print on a calibrated Creality K2 / Bambu A1, QC and post.
Need a masquerade mask, but just can't quite fit the Low Polygon Mask into your Replicator print volume?
Well, stop fretting and use OpenSCAD to trim some tiny edges off!
2013-01-01: At the last minute I slapped together and printed a stick that worked quite well as a handle (once a little silver duct tape was added on the inside of the mask). It's not perfect, but for being a ten-minute design it worked very well!
2013-01-02: Fixed the gap in the CC license-chain by switching from CC0 to CC-BY-NC-SA.
