Mini-Me v4 lightweight Ender3 Hotend Duct (Stock Parts, 5015, No Soldering)

Mini-Me Duct for Ender 3
---------------------

This project will move to printables in the future, as I'm having problems with thingiverse's stability and spam.
https://www.printables.com/de/model/197957-mini-me-v4-lightweight-ender3-hotend-duct-stock-pa

This is a custom hotend duct, which uses the stock fans and improves part cooling.
There is also a version for a single **5015 blower fan available**.
It should be compatible with any printer that uses this mk8 hotend style (CR20, CR10, ..)

I always wanted to improve my part cooling, but thought that the available options for ducts were clunky, take a long time to print or restrict precious airflow. They usually block the view to the nozzle, making it hard to verify a good first layer.

The MiniMe Duct is smaller and lighter than the stock metal housing and has optimized ductwork, which converges the cooling stream right under the tip of the nozzle. It uses only 12g of material, as the design is optimized for minimal support and post processing. You can print this part and start installation immediately, as **no additional hardware is necessary**. (a ziptie would be nice though)

**Please use the silicone sock of your heater, as it will protect the duct from direct heat. I covered the right duct with two layers of aluminum foil, as this side of the hotend ist not covered and did deform previous versions. (see photos)** The heater cartridge was also sliding out a bit and caused a high temperature spot, you…