Customizable pipe cap (fusion360)

--- Hi, the total length of the cap has been shortened. What you see in the photo is still the long one. Excuse me.---

This is the end cap of the pipe. It can handle various pipe diameters.
Customization is done by changing the parameters of fusion360 file (.f3d).
Even if you're not using fusion360 right now, it's easy to install fusion360 and change its parameters, so give it a try.

I designed some pipe caps.
-Customizable pipe cap https://www.thingiverse.com/thing:4795549 ...this thing
-Customizable Pipe Cap "Cover type" https://www.thingiverse.com/thing:5150957
-Customizable Rectangle Pipe Cap https://www.thingiverse.com/thing:4875215
-Customizable Rectangle Pipe Cap "Cover type" https://www.thingiverse.com/thing:5153134


[Features]
-Customizable
-Fixed firmly
-Hard to break even if squeezed strongly with a wrench
-Easy to remove from the pipe
-Easy to print(no support)

[Design point]
Designed so that when the bolt is tightened, the bolt is parallel to the pipe. This enabled stable tightening.


[Bolt/Nut type to use]
type: CAP bolt and Nut M3 - M6
bolt length: The needed screw length is approximately equal to or greater than the pipe diameter.


[Customizable parameters]
-Inner diameter of pipe (min:10mm at M4, max: no limit)
-Flange diameter (min: inner diameter of pipe, max: no limit)
-Flange thickness (min:0.1mm, max: no limit)
-Flange chamfer
-screw size (M3, M4 ,M5, M6 ) screws larger than M6…