Drawer Slide v3 Alignment Jig/Tool - Double Sided
Have us print this for you
PLA from £6 inc. UK delivery on letter-sized prints. We slice, print on a calibrated Creality K2 / Bambu A1, QC and post.
Remixed, my previous remix. Rather than a left and right model, there is one double sided jig. I made the full extension holder a separate adapter, rather than being integrated. I also made a cutout notch for the wheels of 3/4 extension drawer slides.
As stated in the previous model: The bubble level acts as an additional sanity check, and eliminates the need to balance a level atop of the drawer slide.
Added a spot to integrate a bubble level.
Added an adapter to hold/support the a full extension drawer slide during installation.
Added an adapter to hold the drawer "member" for installing to the drawer box.
Added an adapter to hold a 3/4 extension style drawer slide.
There is an adapter for holding the drawer's "cabinet member", and a spot to snap in a bubble level. The squareness of the jig should already provide a level surface, but the addition of a bubble level provides an additional sanity check.
There is an insert/adapter for helping to line up and hold the "drawer member".
There is an additional (optional) insert/adapter for using with smaller 3/4 extension drawer slides. There is a cutout to ensure the protruding front wheel does not cause an alignment issue.
Printed with 4 line/wall perimeter (rather than 2), and lower 5% infill. Shorter print time, lower filament use, but the strength remains. (If only using 2 perimeters, than 5% infill will be insufficient). I printed at 0.2mm resolution, with PLA+ (rather than regular PLA).
The individual…
