Whetstone Sharpener Helper / Sharpening Guide
by EpicHardware · from Thingiverse
Free to print
♥ 1,877 likes
↓ 7,832 downloads
Have us print this for you
PLA from £6 inc. UK delivery on letter-sized prints. We slice, print on a calibrated Creality K2 / Bambu A1, QC and post.
Designed to fit a 180 x 60 x 15mm sharpening stone. Also solve the sliding issue from the original design.
The sharpening angle is 16 degrees, meaning is razor like sharp. Be careful!
I tested in my japanese knife and i have blown away by the results!
I was sharpening all these years without any helper, and it turns out i never managed to get a good angle. This device did in the first try!
One thing i was worry about the design is that plastic on plastic, it wouldn't slide well. After testing is i can verify that this is not the case. When is yet with water is super slippery and therefore a non issue.
