RC Snow Tracks - No Hardware
Have us print this for you
PLA from £6 inc. UK delivery on letter-sized prints. We slice, print on a calibrated Creality K2 / Bambu A1, QC and post.
RC Snow Tracks for 1/10 scale models.
It should fit any car with a standard 12mm Hex Wheel Mount.
UPDATE - 2026-01-01
- Added Bigger Idle Wheel (To remove a bit of slack on old set of tracks)
UPDATE - 2025-03-30
- Added V2.1 (Front and Rear LONG)
Small modification to the Anti-Rotation Holder to make the sharp corners less prone to breaking.
Front Frames are now 3.2mm longer to remove a little bit of slack.
- Added a Model #2 for the PLA Paddles (Same model as the TPU version, but the clips are for PLA)
They work fine in the snow, but drive very carefully on hard surfaces or you will break a lot of those sharp corners.
UPDATE - 2023-06-14
- Added Single Link. Could be useful if you have problems printing the tracks as a print-in-place mechanism. (Some people got tracks that were all stuck together and would not move). Feel free to print every link separately but you will need cotterpins for every junction. I haven't tested this however... The whole track could end up being too loose.
**IMPORTANT UPDATE - 2023-01-11**
- Added straight cotter pins for the tracks (__Using filament pieces still works in a pinch but not recommanded.__ Unprinted filament become brittle when exposed to moisture and tend to break in little pieces inside the joint, causing uneven stress on the tracks tiny loops). Print those cotter pins at 100% zig-zag infill and they will last much longer than unprinted filament. Even better if you can make them in TPU, they will absorb shock…
