Pochita (Chainsaw Man) FDM - separated parts
Have us print this for you
PLA from £6 inc. UK delivery on letter-sized prints. We slice, print on a calibrated Creality K2 / Bambu A1, QC and post.
❅ ❄ ❆ ❄ ❅
Added Christmas accessories:
• SAW FROM SNOWFLAKES (2)
A little asymmetrical (old), for the same number of layers of snowflakes.
If the top is smaller than the bottom, try turning it over.
- do not pay attention if you use new (v2).
• LITTLE HORNS (2)
Don't even try to print the "hard_print" version ;)
• RED NOSE
It is better to print with supports and the quality is higher.
• SCARF
Добавлены рождественские аксессуары:
• ПИЛА ИЗ СНЕЖИНОК (2)
Немного асеметрична (старая), для одинакового количества слоёв снежинок.
Если сверху меньше чем снизу - попробуйте перевернуть.
- не обращайте внимание если используете новую (v2).
• МАЛЕНЬКИЕ РОЖКИ (2)
Даже не пытайтесь печатать "hard _print" версию ;)
• КРАСНЫЙ НОС
Лучше печатать с поддержками и качество повыше.
• ШАРФ
❅ ❄ ❆ ❄ ❅
---
I changed:
• the location of the tail is moved lower;
• the shape of the back handle;
• my top handle (shape closer to anime);
• my tail cord;
• made a model of supports for the tongue, teeth and rear hole for the back handle.
It is better to print 120% (height 6 cm) and above. On my model 5 cm high, the teeth and teeth on the saw were lost.
Separate parts can be printed with plastic of different colors.
Eyes rotate, you can change the point where Pochita looks.
Don't forget to thank the author of the original model https://www.thingiverse.com/thing:5644486
Я изменил:
• расположение хвоста перемещено ниже;
• форму…
