Fallout Holotape MicroSD Card Storage *revised*
Have us print this for you
PLA from £6 inc. UK delivery on letter-sized prints. We slice, print on a calibrated Creality K2 / Bambu A1, QC and post.
As a fallout fan I was very glad to find this original by Mrmunoz2616_.
But after printing and using I found 2 big flaws.
1. The µSD-cards are to lose or to firm in place. Also removing the µSD-cards was not optimal. So I decided to make a complete redesign of the slider.
I extended the slider as there was unused space in the case.
I designed a microsd slot so you can remove a card with two fingers.
To do so, press the short part of the card downwards into to slider. By doing so the long side should move into the air. With the second finger you can now grab under the card and remove it without big effort.
2. The slider fell of the case. So I made holes for 4 3x2mm high power neodymium magnet. I glued them with CA in place. Pay attention for the correct polarity of the magnets.
On my Anycubic Mega 3S the 4 µSD-card slots have a lightly tight grip.
The other 6 are optimal.
Depending on the accuracy of your 3d-printer you should test if the µsd-card fit proberly.
