Customizable cable organizer
Have us print this for you
PLA from £6 inc. UK delivery on letter-sized prints. We slice, print on a calibrated Creality K2 / Bambu A1, QC and post.
###Introduction
Tired of tangled wires and cables and looking for a way to solve the mess? Seek no more!
This customizable cable organizer can be fitted to almost any cable with just a few and easy measurements.
With this cable organizer you can be sure to always keep your cables in order.
###Why did I make this?
All of my cables used to be wrapped around themselves and thereby creating a possible mess of tangled wires. Therefore, I thought to myself that a 3D printer could bring me a solution. From then on, I came up with this design which I am very pleased with.
I also made a simple stand which, should be able to hold the cable organizers.
###How to make your own cable organizer…
**Note:** To make your own cable organizer you will need Fusion360 or to use the customizer on [Makerworld](https://makerworld.com/en/models/992630-customizable-cable-organizer#profileId-975167).
[Fusion360 is available for free on Autodesk.com (for personal use only).](https://www.autodesk.com/products/fusion-360/personal)
Since almost all cables are different, you need to do a bit of measuring of your cable.
You need to measure the following:
1. **The thickness of your cable in mm.**
I did this by using a caliper and taking numerous measurements to correct any possible errors.
2. **The length of the cable in mm.**
Be sure to measure only the cable length **without** the end plugs/connectors (as shown in the image below).
Keep in mind, that it is better to measure the cable too short…
