check out the new version 2
http://www.thingiverse.com/thing:1019228
version 3
http://www.thingiverse.com/thing:1363023
more infos in our forum
http://www.whoote.com
This is a hard to print testfile!
often you don't know if your printer is ready for complex files. with this file you have an easy option to check problematic printing/slicing stuff.
does your printer challenge this ultimative part?
check it out and get (almost) instant results.
these test are included in this tiny file:
- size: the object is 4x50x50mm (baseplate)
- hole size: 3 holes (3/4/5mm)
- Nut size: M4 Nut should fit perfectly
- fine details: pyramide, cone, all numbers
- rounded print: wave, half sphere
- minimum distance between walls: 0.1/0.2/0.3/0.4/0.5mm
- overhang: 25°/30°/35°/40°/45°
- bridge print: 2/3/4/5/6/7/8/9mm
- surface: all the flat parts
there could be a lot of things go wrong, here the most common ones
- your printbed is not leveled (should be better than layerheigth you're printing, e.g use a Micrometre)
- your axis (Y/X/Z) clearence (with higher speed you also get problems with the moving mass)
- your slicer and configuration (every slicer handles things different and could contain bugs)
- retract settings (not correctly set you will see blobs or holes on every retract position)
- to high temperature (small details will get overheated)
- to reach this time, your printer should run between…
