Have us print this for you
PLA from £6 inc. UK delivery on letter-sized prints. We slice, print on a calibrated Creality K2 / Bambu A1, QC and post.
This is a small networking device that allows you to configure an IP Address and Subnet Mask, then plug into your network and you can ping this device from a remote location using a PC.
The device has uses a Waveshare RP2040-ETH board to handle the ethernet connection, drive the OLED display, handle the button presses and reprogram the boards IP and Subnet.
It has a 400 mAh battery and is charged using a TP4056 Battery charger.
The RP2040-ETH only has a 10Mb connection speed, so will not be able to connect to a switch or PC that cannot handle a 10Mb connection.
Future Upgrades:
- 100Mb Connection speed
- Device that can ping as well as be pinged
- Improve 3D prints to fit flush without Blue Tack filler
