Raspberry Pi Zero & Zero 2 Case - Snapfit, Screwless, inc. camera slot
Have us print this for you
PLA from £6 inc. UK delivery on letter-sized prints. We slice, print on a calibrated Creality K2 / Bambu A1, QC and post.
Raspberry Pi Zero and Pi Zero 2 Case
-----------------------------------------
Year 2025 - note there is an improved version of this case here: [https://www.thingiverse.com/thing:6990146](https://www.thingiverse.com/thing:6990146) this version improves on the HDMI connector compatibility.
+ Compatible with old & newer **Pi Zero**, **Pi Zero 2** & **Pi Zero W** (includes a camera ribbon slot)
+ Snap fit design - *no screws required*.
+ Heat sink hole for the 2W variation.
+ "Coin slot" provided to prise lid open.
+ Easy to insert the Pi into the case
+ Screw holes case for screwing through back of case for mounting plus other mountings
+ Vented lids to let Pi breath
+ Small IO & larger IDE style connector slot version
+ Extra deep version is for use with IO port connector soldered to board, thus needing room for pins to stick out under the board.
+ 2020 extrusion adapter, https://www.thingiverse.com/thing:5180242
If using the internal screw holes, ensure the screw head is not going to short against the Pi, I'd recommend some electrical insulation tape over the top of the screw heads before mounting the Pi for peace of mind.
**Note:** You may need tweezers or fine nose pliers to take out the SD card once inserted, design compromise to keep the design simple and neat.
The Pi is very snug in its case to keep the footprint to smallest I could.
Feed camera ribbon through slot and insert into Pi, then lower Pi into place.
**Download all files as zip** to see full filenames…
